BERRIDGE VANTAGE POINT RETROFIT ROOF SYSTEM

 

PRODUCT INFORMATION

Berridge Vantage Point Retrofit Roof System is a re-roofing system that uses a simple mechanical framework engineered for installation over an existing flat, built-up roof. Vantage Point is more than just a patch-up or a re-roof solution; it is a permanent new roof with a new higher profile which gives your old building a totally new look. The sloped, light weight, self supporting metal panels need no substrate, thus avoiding extra weight and cost. They provide a watertight standing seam metal roof that sheds water in contrast to dated, flat, built-up roofs which are subject to water ponding and subsequent leakage.

  • Use Berridge Zee-Lock or Cee-Lock standing seam metal roof systems
  • Economical, no tear-off required
  • Single-source convenience
  • Solid decking or open framing
  • Add insulation in space between old and new roof
  • Hide mechanical equipment on flat roofs

MATERIALS

  • Standard material is 24-Gauge & 16-Gauge, Galvalume®
  • 24-Gauge material may be mixed colors, painted/unpainted, secondary/prime

ASSEMBLY

Vantage-Point-Assembly

COMPONENTS


16-Gauge
Cee-Channel
2-1/2″ x 4″
?

16-Gauge
Eave Strut
2-1/2″ x 4″
?

16-Gauge
Zee-Purlin
2-1/2″ x 4″
?

16-Gauge
Sloped Zee-Purlin
2-1/2″ x 4″
?

24-Gauge
Hat Channel
1-5/8″ x 5-1/16″
?

16-Gauge
Open Track
2″ x 4-1/4″
?

INSTRUCTIONS

? 16 GA Cee-Channel: connect each end with (4) #12-14 self-drilling fasteners.
? 16 GA Eave Strut: connect to beam with (2) #12-14 self-drilling fasteners.
? 16 GA Continuous 4” x 2-1/2” Zee-Purlin Roof Support.
? 16 GA Continuous 4” x 2-1/2” Retrofit, Sloped Zee-Purlin.
? 24 GA Hat-Channel: connect to beam with (2) #12-14 self-drilling fasteners each flange.
? 16 GA Open-Track x 1’-0” Long: anchor into wall, connect to beam with (2) #12-14 self-drilling fasteners each flange.
? 24 GA 2” Bottom Flange Strapping at Purlin mid-span: connect to purlin with (1) #12-14 self-drilling fastener.

Disclaimer: Project specific engineering required. Consult Engineering Department for pricing. Suggested detail shown above may not be applicable to every project.